Q: We currently have a Hayward H250 natural gas heater on our 16’ X 28’ In ground pool and have thought about replacing it with a heat pump. Several years ago I installed a 2 speed pump on the pool and we now save a lot of kilowatts by using the lower speed. However when we want to heat the water we must run the pump on high speed to meet the gas heaters minimum pressure requirement. It’s not really much of a problem because we only use the pool from mid May till mid September and with the solar cover on it holds the heat in pretty good unless we have some unusually cool weather. We also have what I call an indirect solar heating system on the pool that adds a little extra heat as well so we don’t have to run the gas heater very much once we get the water up to temperature. As such I was wondering if the heat pump pool water heater that you use requires you to run your pool pump on high speed to keep your water warm?
My indirect solar pool heating system consists of 400’ of polybutylene tubing that I put in the concrete that surrounds the pool. I feed it with pool water coming off a tee fitting that I installed after the filter but before the heater. Of course I have a ball valve installed so that I can shut it off at night. Once the water exits the 400’ of tubing that is buried in the concrete it just gravity flows back into the pool. I can send you som photos of it if you’re interested in learning more about it. Another benefit of using this indirect solar system or maybe we should call it a reverse radiant system is that it keeps the concrete a little cooler on those very hot sunny days. My grandkids really appreciate that.
A: This sounds like a well thought out installation – I like the passive pool heater which heats the water and cools the deck, a very nice two-for! I think this would work on most pool decks, but obviously you need to do this from the start. If I were designing a pool from the start I would also connect the pool heat-pump heater to the house AC system, but that is a different subject, you can read more about it here if you like: https://greenzerocarbonhome.com/2020/07/free-ac-in-my-house-from-heat-pump-heaters-for-swimming-pools-and-heat-pump-hot-water-tanks/
Our pool heat pump is made by AquaCal and it has proven to be both reliable and efficient. When we installed it, we left the old propane heater in place but we no longer use it at all. If it did not cost me money to take it out, I would have taken it out by now.
The heat-pump pool heater does have a minimum water-flow requirement to work and on our pool and it is at about 1,400 rpm on the variable-speed pump motor for the water-circulating pump. I usually set the water pump at 2,000 rpm so that it circulates the entire pool volume once per 24 hours, which is necessary to keep the pool water filtered. So it is usually enough flow to allow the heater to come on. However, if the skimmers and filter are clogged, the heat pump will shut down because the water flow is insufficient even at 2,000 rpm.
The pool-water circulating pump now runs 24/7 at 2,000 rpm compared to the old fixed-speed motor that ran at 3,450 rpm about 12 hours a day. This alone is saving me about 75% of the electricity used to run the pool. If you already have a 2-speed motor it is probably not going to save you a lot more money to go with a variable-speed motor. But when you need to replace the pump, I would recommend a variable-speed one as then you can set it to the lowest flow rate needed to circulate the entire pool volume in 24 hours. There is a lot more information on how we got to a zero-carbon footprint on our pool in the book Zero Carbon Pool which you can order here: https://greenzerocarbonhome.com/shop/